Omnipure CL10PF5-B 1/4" FNPT Inline 5 Micron Sediment Replacement Water Filter

$10.99
In stock

Omnipure CL10PF5-B 1/4" FNPT Inline 5 Micron Sediment Replacement Water Filter

Omnipure CL10PF5-B 1/4" FNPT Inline 5 Micron Sediment Water Filter

Specifications

Flow Rate

0.5 gpm

Maximum Operating Pressure

125 psig

Operating Temperature

2 to 38 ºC35 to 100 ºF

Rated Capacity

Dependent on Influent Water Quality

Reduction Claim

Dirt, sand, and sediment reduction

Service Flow Rate

0.75 gpm2.8 L/min

Standards

ANSI (American National Standards Institute)NSF (National Sanitation Foundation)

Uses

Icemakers, Refrigerators, Under-the-counter, Drinking fountains, Beverage Equipment, R.O. Systems, and in Conjunction with Commercial Purification Systems.

General Installation / Operation / Maintenance Requirements

  • Note flow direction of filter.
  • For quick connect fittings, push scratch free tube end that has been cleanly and squarely cut into the fitting until it bottoms. Threaded fittings must be wrapped with PTFE tape before installation. Install PTFE taped fittings and tighten firmly. Use two wrenches to firmly tighten tubing.
  • Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. 
  • Replace cartridge when rated capacity is reached, or when flow becomes too slow.
  • Install in compliance with state and local laws and regulations.

Additional Information

Furthermore, no glues or binders that may cause contamination are used in the manufacturing process. Instead, components are friction-welded together, producing a reliable, no-leak seal. And finally, all threaded connections are precision cut by machine with results in the more accurate and repeatable thread possible.

Special Notices

  • The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
  • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
You may also be interested in the following product(s)